I am looking for V10 1T7T 11C20…

We do not stock any V10 pumps with the "T" 1-3/16-12 inlet and 3/4-16 outlet ports.

However, we do have the V101S7S 11C20 with a 1-5/16-12 inlet port and the same 3/4-16 outlet port in stock. Perhaps you could change the the inlet port hose or pipe?

AT: VENTAS
ESTAMOS BUSCANDO UN MOTOR HIDRAULICO A PALETAS MARCA
VICKERS MOD . 50 M
DATOS 12/07 185.L B
AGRADECEMOS ALGUNA INFORMACION
O A DONDE DEBEMOS DIRIGIRNOS PARA DICHA CONSULTA
Y POSTERIOR COMPRA
SALUDOS

The 50M is no longer available, but you may be able to get some parts. You can use this PDF to get part numbers.

I have pump with V214 5 1B 12 on top line 43 in a square box with S214 to the right of it on lower line. It is powered with electric motor. I am not able to find this model to determine what it will do can you help?

Here is a PDF which will give you some information about your old V214 5 1B 12 vane pump. It is no longer available.

If you need to replace it you will need to get a V20 1P 6P 1C 11. It is very similar but is 6 GPM instead of 5 GPM. Our part number is 296760.

We are looking 2 hydraulic vane pumps for a sheet machine with the number V10 1B7B 1C20. It is a 0.2 Cubic Inch Displacement with a 2 bolt SAE mounting flange,3/4 staight keyed flange and 1" NPT scution by 1/2 NPT pressure ports.

It sounds like you are describing the V10 1P7P 1C20.

I have an 11hp honda with a 2-1 reduction driving what looks like an old vickers power steering pump with the pot on top. I have had it tested and it has a constant flow of 13liters pm (at any revs) at 3000psi. I have obviously over powered it as I can stall the two fishing winches with the motor only a bit above an idle and only loads it a little. It has no numbers on it and the identifying tag it appears to have had is missing in action. I would like to know what it is so I can get another one and couple it up with the right size engine. I use it with a splitter and drive two large deck winches for fishing in deep water (300 to 800 meters) or singularly to drive the crab pot winch.

The pump you describe is most likely a VTM Pump as it was commonly used on fishing boats. We do carry the most common version and can get the others.

Here is a link to the Eaton / Vickers product information PDF, Page 89 which will provide more information about the VTM Pump.